How do I run EVO Lite Enterprise gimbal auto-calibration?

Applies to

EVO Lite 6K Enterprise EVO Lite 640T Enterprise

EVO Lite 6K Enterprise and EVO Lite 640T Enterprise aircraft with the SE V2 remote controller; Premium Kit controller instructions are excluded.

Firmware scope: not specified in this answer. English manufacturer manual; Canadian flight permission and applicable local rules are not determined by this source.

The gimbal is factory-calibrated and usually does not need user-initiated calibration. If the flight app prompts “Please calibrate the gimbal motor,” place the aircraft on a flat surface and keep it stationary while you run the app’s gimbal calibration.[1]

Before you begin

Do not move the aircraft during calibration. Use the procedure when prompted by the app; the manual says user-initiated auto-calibration is typically unnecessary otherwise.[1]

Follow these steps

Set the aircraft in place
Place the aircraft on a flat surface. Turn on the aircraft and remote controller, and keep the aircraft stationary.[1]
Start calibration in the flight app
From the flight interface, open the calibration controls shown in the app and select Start calibrating for the gimbal. Wait until the screen reports calibration success.[1]

Sources & review

1. EN_EVO Lite Enterprise Series Aircraft User Manual_V1.0.2.pdf
2.12.3 Gimbal auto calibration · physical PDF page 40 (printed 29) · blocks 10, 11, 13, 14
Manual & edition details · View original source ↗
Original PDF visually checked 2026-10-17. Drive access may be required.
Evidence identity
sha256:775f2386515122d0ddeee8c4f9509b4e48ef4074e145b008ae9c9b76258fba01/extraction-page:40/blocks:10,11,13,14

Reviewed by Codex · source review. Source-reviewed against the cited original PDF pages and prepared MinerU blocks. This AI-assisted review is not manufacturer, human technician or field-test approval. Updated 2026-10-17.

Follow these steps

Set the aircraft in place

Start calibration in the flight app

Sources & review