Search the manuals.
Find instructions, diagrams, specifications and answers. Search the full EVO Lite 640T manual, or filter by aircraft.
98 results
- Reviewed answer
How do I charge the EVO Lite Enterprise remote controller? →
Use the official Autel remote-controller charger. Connect its USB-A output to the controller’s USB-C port with the USB-A-to-USB-C cable, then plug the charger into a 100–240 V AC, 50/60 Hz supply. Use the charger provided by Autel. The manual warns that a third-party charger may damage the remote-co…
- Reviewed answer
How do I charge the EVO Max remote controller? →
For the EVO Max 4T XE and 4N described here, connect the official remote-controller charger to the Smart Controller V3’s USB-C port using either a USB-C-to-USB-A or USB-C-to-USB-C data cable. Connect the charger to a 100–240 V AC, 50/60 Hz supply. Use the official charger supplied by Autel; the manu…
- Reviewed answer
How do I create a waypoint mission for EVO Lite Enterprise? →
In the EVO Lite Enterprise flight app, open the Waypoint mission interface and create a route with at least two waypoints. Set the route’s altitude reference and mission behaviour, then review the route and complete the app’s pre-flight check before starting it. If obstacle avoidance is set to Off, …
- Reviewed answer
How do I link an EVO II RTK V3 aircraft to its remote controller? →
Autel’s RTK Series V3 manual names both the Pro RTK V3 and Dual 640T RTK V3 configurations. A whole package that includes an aircraft and remote controller is already linked before delivery. If manual linking is needed, use the aircraft linking button and Autel Explorer app procedure below. Autel sa…
- Reviewed answer
How do I pair a Dragonfish Standard aircraft with its remote controller? →
Dragonfish Standard kits are normally paired with their supplied remote controller and base station before delivery. If the base station is not in use or the aircraft and remote controller have become unpaired, use Autel Voyager’s Datalink frequency matching procedure. Keep the aircraft and controll…
- Reviewed answer
How do I replace EVO Lite Enterprise propellers? →
Autel says to replace damaged propellers before flight. Power the aircraft off first, use the supplied Autel propellers, and match each CW or CCW propeller to the mount with the corresponding center-shaft marking. Propellers have sharp edges and can spin up to 8,000 RPM. The manual recommends protec…
- Reviewed answer
How do I run EVO Lite Enterprise gimbal auto-calibration? →
The gimbal is factory-calibrated and usually does not need user-initiated calibration. If the flight app prompts “Please calibrate the gimbal motor,” place the aircraft on a flat surface and keep it stationary while you run the app’s gimbal calibration. Do not move the aircraft during calibration. U…
- Reviewed answer
How do I update EVO Lite Enterprise aircraft and controller components? →
Autel’s manual says the flight app can manage updates for multiple UAS components. The documented Update All procedure updates the aircraft and remote controller; make sure they are already paired, both batteries are above 25%, and the controller has internet access. Before updating the controller, …
- Reviewed answer
How does DJI Dock 4 swap and charge the Matrice 5TD battery? →
DJI Dock 4 automatically swaps or charges the Matrice 5TD after landing according to the aircraft battery level and task schedule. It swaps when the aircraft battery is below 90%, a task is scheduled within one hour, and a battery in the dock compartment is above 90%. Do not install or remove the ai…
- Reviewed answer
How does obstacle avoidance work during EVO Lite Enterprise Return-to-Home? →
During RTH, the EVO Lite Enterprise can brake and hover when it detects an obstacle in front, but only when obstacle avoidance is enabled and lighting lets the visual-perception system work. The operator must then take over manually. The aircraft can remain hovering until critically low-battery land…
- Reviewed answer
How does Return-to-Home work on the EVO Lite Enterprise series? →
The EVO Lite Enterprise manual describes three RTH trigger types: manual activation, low-battery activation and configured behavior. With a good GNSS signal, an activated return sends the aircraft toward its home point and landing. If the app has no home point set, the manual says the takeoff point …
- Reviewed answer
What are the EVO Lite Enterprise battery specifications? →
The aircraft manual specifies the MDXM_6175_1113 battery: Li-Po 3S, rated capacity 6,175 mAh, energy 68.7 Wh and nominal voltage 11.13 V. The charging temperature range differs from the operating range. If battery temperature exceeds 45°C after flight, let it cool naturally below 40°C before chargin…
- Reviewed answer
What happens when an EVO Lite Enterprise battery becomes low during flight? →
For the EVO Lite 6K and 640T Enterprise, the flight controller can initiate return-to-home (RTH) when its position-based estimate says the remaining battery is only enough to return, or when the low-battery threshold set in the flight app is reached. For the position-based alert, the app gives a 10-…
- Reviewed answer
What information should I prepare for Dragonfish Lite maintenance service? →
For a Dragonfish Lite repair request, prepare your name, email address, mailing address, phone number, product name, and a complete description of the problem with a photo. The manual also lists proof of purchase for warranty requests and a preferred payment method for non-warranty service. Back up …
- Reviewed answer
What routine inspection does the DJI O4 Ground Station manual recommend? →
DJI recommends inspecting and patrolling the O4 Ground Station once every six months. The manual describes inspection checks but does not provide repair steps. Arrange qualified service for abnormal or damaged hardware rather than treating this checklist as a repair procedure. Check for obstructions…
- Reviewed answer
What should I check before flying an EVO II Pro V3? →
Before each flight, Autel directs Pro V3 operators to check the aircraft, remote controller, mobile device, flight area, weather, firmware, camera and sensors. The manual says the aircraft cannot take off when battery level is 15% or lower. It also warns that the motor becomes hot during operation. …
- Reviewed answer
What should I check before flying an EVO Lite Enterprise aircraft? →
Autel’s v1.0.2 manual calls for a comprehensive check before every flight. For the EVO Lite 6K and 640T Enterprise, work through these aircraft, controller and app checks before takeoff. The manual specifically instructs operators to address every warning or error shown in the flight app and to conf…
- Reviewed answer
Why is my EVO Lite Enterprise battery not charging? →
Temperature protection can stop charging below 5°C or above 45°C. After a flight, a battery hotter than 45°C must cool below 40°C before it can charge. Do not charge a battery that is swollen, leaking, smoking or visibly damaged. Do not use damaged charging equipment or modify the battery or charger…